Metal Garages in Aiken County, SC 2026 | Benton Metal Depot

Permits & Setbacks in Aiken County

Permit Authority Name Aiken County Planning and Development Department (Building Codes/Inspections Division)
As of 2026 · Source
Permit Authority Url https://www.aikencountysc.gov/forms/pnd_buildingpermit.pdf
As of 2026 · Source
Permit Threshold Sqft 200
As of 2026 · Source
Setback Feet Side Rear Per Aiken County Code of Ordinances Ch. 24, Art. VIII: on parcels under 2 acres, total accessory-building floor area may not exceed 50% of the principal structure's gross floor area; accessory buildings in a required setback area are capped at 12 ft in height (20 ft if outside the setback area). Exact side/rear setback distances for freestanding detached accessory buildings by individual zoning district were not fully extracted — verify against the primary ordinance before publishing a specific district-by-district number.
As of 2026 · Source
Wind Load Zone Inland South Carolina (Aiken borders Augusta, GA, well away from the coast) — roughly 105-120 mph (ASCE 7, Exposure C). NOT a verified figure; exact design wind speed depends on the ASCE 7/IBC edition Aiken County has adopted and must be confirmed with an SC-licensed engineer or the county building official.
As of 2026 · Source
Coastal
As of 2026 · Source

Get Your Free Metal Building Quote

Tell us a bit about your project and we'll get back to you with a custom quote — no obligation, no pressure.