Reviewed by the Benton Metal Depot team · Updated
A garage doesn't have to be just a place to park the car. Property owners in Wefanie can use metal garages to store cleaning equipment, different kinds of tools, storage and it can be used as a work space, too. Benton Metal Depot serves customers across Long and can help you find the building depending on how the space will actually be used.
Key Points
- ◦Doors, windows and other selections can change the final cost of a garage.
- ◦Benton Metal Depot is approximately 59.3 miles from Wefanie.
- ◦A metal garage can be used as parking, storage, equipment and work space under the same roof.
- ◦Delivery to Wefanie is currently estimated at 1 to 2 weeks.
- ◦Get the final garage dimensions before completing permanent site work.
At a Glance
| Permit threshold |
Not explicitly published — the county maintains a Land Development Code (PDF) and a building permit application, but no clear sqft exemption threshold for accessory structures was found in it via search. Needs direct confirmation with Code Enforcement (912-545-3683 / codeenforcement@longcountyga.gov).
As of 2026 · Source |
|---|---|
| Setback (side/rear) |
Not found — the Land Development Code likely contains a setback table by district (see Planning & Zoning page), but specific figures were not extractable via search. Needs direct confirmation.
As of 2026 · Source |
| Wind load zone |
Inland Georgia — roughly 110-120 mph (ASCE 7, Exposure C), though Long County is closer to the coast than most counties in this batch (roughly 25-30 miles from Long County to tidewater). NOT a verified figure; must be confirmed with a GA-licensed engineer or the county building official.
As of 2026 · Source |
| Panel type/gauge |
29-gauge and 26-gauge Rib panels -- Benton's existing standard gauge/profile for pole-barn, carport, and agricultural structures.
As of 2026 · Source |
| Drive time from Statesboro |
94
As of 2026 · Source |
Permits & Setbacks in Long County
The permit question for a Wefanie metal garage comes down to one number from Long County Code Enforcement Office: Not explicitly published — the county maintains a Land Development Code (PDF) and a building permit application, but no clear sqft exemption threshold for accessory structures was found in it via search. Needs direct confirmation with Code Enforcement (912-545-3683 / codeenforcement@longcountyga.gov). square feet. Stay under it and skip the full permit process; either way, keep the Not found — the Land Development Code likely contains a setback table by district (see Planning & Zoning page), but specific figures were not extractable via search. Needs direct confirmation. setback in mind before you pick a spot.
Delivery to Wefanie
The current estimate for getting a metal garage to Wefanie is 1 to 2 weeks. The area is about 59.3 miles (94 minutes) from Benton Metal Depot in Statesboro. That gives you a general timeline for scheduling contractors, preparing the property and handling local permits before the building is due to arrive.
Representative product photo — a Long County-specific project photo is pending (rotates in from Trey's weekly upload per the freshness cadence).
FAQ
Can I use a metal garage just for storage?
Yes. Cars don't have to be part of the equation at all. A metal garage can give you enclosed space for tools, lawn equipment, recreational gear and other belongings. If storage is the main purpose, think about shelving and aisle space while planning the building so everything remains accessible once the garage starts filling up.
Do I need a permit for a metal garage in Wefanie?
That depends on the garage and the requirements of Long County Code Enforcement Office. The current rule requires a permit once the garage exceeds Not explicitly published — the county maintains a Land Development Code (PDF) and a building permit application, but no clear sqft exemption threshold for accessory structures was found in it via search. Needs direct confirmation with Code Enforcement (912-545-3683 / codeenforcement@longcountyga.gov). square feet. Check before doing any permanent site work. There may be other requirements tied to your property as well, so getting an answer early can save you from having to change plans later.
What do I need to do to my property before the garage arrives?
First, decide exactly where the garage will go and check the permit and setback requirements with Long County Code Enforcement Office. Then follow the site requirements for the garage you've selected. Any grading, concrete or other preparation should be based on the final building specifications. Don't prepare the site using rough dimensions if the building hasn't been finalized.
Are metal garages a good choice for Georgia?
Metal buildings are utilized throughout Georgia for garages, equipment storage and other residential, agricultural and commercial uses. The important thing is choosing a building appropriate for the project and location. If you're building in Wefanie, make sure the garage specifications and site plan also meet the local requirements that apply to the property.
Can I use my metal garage as a workshop too?
Definitely! Just plan for the workshop before deciding on the garage size. A workbench, toolboxes, shelving and equipment can eat up a lot of floor space, especially when you're also parking a vehicle inside. Make sure to give yourself enough room to work comfortably instead of trying to fit a workshop into whatever space happens to be left over.
How far is Benton Metal Depot from Wefanie?
Benton Metal Depot's Statesboro location is approximately 59.3 miles from Wefanie. The company serves residents throughout Long, including communities such as Smiley Crossroads, Donald, Elim and Ludowici. Current delivery time for a metal garage to the Wefanie area is about 1 to 2 weeks.
How close can my metal garage be to the property line?
The current setback in Wefanie is Not found — the Land Development Code likely contains a setback table by district (see Planning & Zoning page), but specific figures were not extractable via search. Needs direct confirmation., although you should confirm the requirement for your particular property with Long County Code Enforcement Office. A setback controls how close the building can be to certain property boundaries. Check that distance before you settle on a location, especially when space on the lot is tight.
Can I put a metal garage beside my house?
You may be able to, but don't assume every open spot on the property is buildable. Long County Code Enforcement Office has requirements that can affect garage placement, including a current setback of Not found — the Land Development Code likely contains a setback table by district (see Planning & Zoning page), but specific figures were not extractable via search. Needs direct confirmation.. Check the rules for your address before choosing the location, particularly if you're working with limited room between the house and property line.
Definitions
- ◦ Concrete Slab
- A flat poured-concrete surface commonly used as the finished floor and part of the foundation system for a garage.
- ◦ Eave Height
- The height of the sidewall measured to the point where the wall and roof meet.
- ◦ Trim
- The finished metal pieces used along corners, roof edges, openings and other transitions on the building.
- ◦ Walk Door
- A regular entry door that lets you enter the garage without opening one of the larger vehicle doors.
- ◦ Wall Panel
- Formed metal sheet used to enclose and protect the exterior walls of the garage.
- ◦ Clear Span
- Open floor space between the building's exterior supports without interior columns getting in the way.
- ◦ Roof Pitch
- How steep the roof is, usually described by how much it rises over a set horizontal distance.
- ◦ Gable
- The triangular wall section found at the end of a building with a pitched roof.
- ◦ Setback
- The required amount of space between your garage and a property line, road or another boundary covered by local rules.
- ◦ Fastener
- A screw or other connector used to hold metal panels and building components securely in place.
Wefanie, Long County — At a Glance
- Permit Authority Name
- Long County Code Enforcement Office
- Permit Authority Url
- https://www.longcountyga.gov/code-enforcement
- Permit Threshold Sqft
- Not explicitly published — the county maintains a Land Development Code (PDF) and a building permit application, but no clear sqft exemption threshold for accessory structures was found in it via search. Needs direct confirmation with Code Enforcement (912-545-3683 / codeenforcement@longcountyga.gov).
- Setback Feet Side Rear
- Not found — the Land Development Code likely contains a setback table by district (see Planning & Zoning page), but specific figures were not extractable via search. Needs direct confirmation.
- Wind Load Zone
- Inland Georgia — roughly 110-120 mph (ASCE 7, Exposure C), though Long County is closer to the coast than most counties in this batch (roughly 25-30 miles from Long County to tidewater). NOT a verified figure; must be confirmed with a GA-licensed engineer or the county building official.
- Coastal
- Drive Miles
- 59.3
- Drive Minutes
- 94
- Nearby Towns
- Smiley Crossroads, Donald, Elim, Ludowici
- Delivery Weeks In Stock
- 1
- Delivery Weeks Custom
- 2
- Panel Type Gauge
- 29-gauge and 26-gauge Rib panels -- Benton's existing standard gauge/profile for pole-barn, carport, and agricultural structures.
- Color Count
- 7
Why Benton Metal Depot
Buying a garage isn't just a matter of picking a picture and choosing a size. You also have to think about what you're putting inside, where it will sit and what materials the project needs. Benton Metal Depot works with residents in Wefanie and throughout the region to help them choose a garage package that will work well with whatever they need.
Ready to talk through your metal garages project in Wefanie?
Sources
- Internal: category-data.php (pole-barns / agricultural-pole-barns copy) (2026)
- color-collection.php Weather XL Rib/PBR color chart: Polar White, Pebble Gray, Granite, Onyx, Vanilla, Sand, Chocolate (29ga; 5 of the 7 also available in 26ga). Real Benton color count for this panel line -- not confirmed as the specific palette Jim/Trey intend to offer for metal garages. (2026)
- https://www.longcountyga.gov/code-enforcement (2026)
- https://www.longcountyga.gov/code-enforcement (Land Development Code PDF linked there) (2026)
- https://www.longcountyga.gov/planning-zoning (2026)
- General ASCE 7 inland-Georgia range (aggregated secondary sources) — no county-specific or primary map source found (2026)
- Long County is not among the coastal counties named in the client spec (per provided coastal flag list) (2026)
- Computed 2026-09-16: GeoNames zip centroid -> OSRM public routing engine (real driving route from Statesboro, Bulloch County, GA). Deterministic and reproducible, but a free public demo routing server, not Google Maps -- spot-check a sample before confirming. (2026)
- Computed 2026-09-16: same OSRM routing result as drive_miles, converted from seconds. (2026)
- Computed 2026-09-16: 4 nearest cities in benton_service_area_cities.php by straight-line (haversine) distance from zip centroid. (2026)
- Bulk-set via dev-fact-review.php (2026)
